Kilsen KFP-AF Series, Installation Manual

Page: 64 / 80

Chapter 5: Technical specifications
60 KFP-AF Series Installation Manual
Input/Output specifications
Input/Output overview
Configurable
outputs
General fire
outputs General fault
outputs 24V AUX
output Inputs
One-loop panel 2 2 (see note) 2 (see note) 1 2
Two-loop panel 4 2 (see note) 2 (see note) 1 2
Two-loop panel with
loop board 8 2 2 1 2
Repeater panel 0 2 2 1 2
Note: 1 supervised output and 1 potential-free relay.
Configurable outputs
Supervision Reverse polarity, end-of-line resistor 15K ¼ W
Maximum output current 750 mA per output at 25 ºC
675 mA per output at 40ºC
Maximum electrical
characteristics for sounder
activation 1 A start-up current (t

2ms), load 100

F
Configurable options Sounder, fire routing, program, fault, fire
Fire and fault outputs
Available output pairs 1 output pair for Fire
1 output pair for Fault (activated when no fault)
Output pair specifications 1 supervised output: reverse polarity, EOL resistor 15K ¼ W
1 potential free relay: C/NO/NC
Maximum output current
Supervised
output
Relay output
350 mA per output for all temperature ranges
2 A / 30 VDC
24V auxiliary output
Maximum output current 500 mA at 25ºC
385 mA at 40ºC
Configuration mode Resettable, not deactivated during reset (default), inactive when
mains off, not deactivated when running on batteries (default)
Inputs
Number of inputs 2 supervised inputs, end-of-line resistor 15K ¼ W
Active input value 62 Ω

active value

2K2 Ω
Short circuit values

50 Ω
Open circuit values

22 k Ω
Configuration mode Activation, logged, external fault, remote reset, UK class change