Kilsen KFP-AF Series, Installation Manual

Page: 44 / 80

Chapter 3: Configuration and commissioning
40 KFP-AF Series Installation Manual
Other settings
24V auxiliary
Select this option to configure the 24V AUX output state during reset and when
the control panel is running on battery power. The default setting for both options
is NO (the 24V AUX output will not be deactivated).
To change the configuration:
1. Select Panel setup from the main menu
2. Select Other settings and then select 24V AUX config
3. Select YES or NO for deactivation during reset
4. Select YES or NO for deactivation when running on battery power
5. Press F4 (Enter) and then press F2 (Exit)
6. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit)
Fault mask
Select this option to configure the reporting status for battery and earth faults.
The default setting for both options is YES (all faults will be reported).
To change the configuration:
1. Select Panel setup from the main menu
2. Select Other settings and then select Fault mask
3. Select YES or NO for battery fault notifications
4. Select YES or NO for earth fault notifications
5. Press F4 (Enter) and then press F2 (Exit)
6. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit)
Note:
If NO is selected for either option, the corresponding faults will not be
recorded in the event log.
Sounders re-sound
Select this option to configure stopped sounder functionality when new alarms
are reported.
NO (default)
Re-sound sounders with any new device in alarm
YES Only re-sound sounders when new zone in alarm
To change the configuration:
1. Select Panel setup from the main menu
2. Select Other settings and then select Sounder re-sound
3. Select YES or NO