Kilsen KFP-AF Series, Installation Manual

Page: 22 / 80

Chapter 2: Installation
18 KFP-AF Series Installation Manual
Connecting outputs
Control panel outputs are shown in the table below.
Table 5: Control panel outputs
Output Description Supervision
24V AUX Used to supply power to auxiliary equipment. The
output can be configured as resettable and to shut
down when there is no mains power. Short circuit, voltage
level
OUT1, OUT2 etc. Configurable outputs (the default configuration is
sounder output). The number of configurable
outputs will depend on the control panel model
(see topic below). Short circuit, open
circuit
FIRE OUT
SUPERVIS This fire output is activated when the control panel
is in alarm status. [1] Short circuit, open
circuit
FIRE OUT RELAY This relay output is activated (a short circuit
between the common (C) and normally open (NO)
terminals of the relay) when there is an alarm. Not supervised
FAULT OUT
SUPERVIS This fault output is activated when the control panel
is not reporting a fault. [1] Short circuit, open
circuit
FAULT OUT RELAY The fault relay output is activated (a short circuit
between the common (C) and normally open (NO)
terminals of the relay) when there is no fault.
Not supervised
[1] For activation voltage, see Chapter 5 “Technical specifications” on page 57.
Output termination
All outputs except the 24V AUX output require a 15 k Ω end-of-line resistor for
termination. If an output is not used, the 15 k Ω end-of-line resistor must be
installed across the unused terminals to avoid an open circuit fault on the output.
Output polarity
All outputs are polarity sensitive. Observe polarity or install a 1N4007 diode or
equivalent to avoid inverted activation issues.
Connecting auxiliary equipment
Connect the auxiliary equipment to 24V AUX as shown in Figure 6 on page 15.