Kilsen KFP-AF Series, Installation Manual

Page: 52 / 80

Chapter 3: Configuration and commissioning
48 KFP-AF Series Installation Manual
Configurable outputs
Configurable options for each output are shown in the table below.
Option Description
OpMode Select this option to assign the output operation mode
Group_n Select this option to configure the output group number
Control Select this option enable or disable an output
Configurable output operation modes are shown in the table below. The default
mode for all configurable outputs is Sounder output.
Table 9: Configurable output modes
Mode Description
SND (default) Select this option for a sounder output
FR Select this option for a fire routing output
PRG Select this option for program options (see below)
Fire Select this option for a fire output
Fault Select this option for a fault output
To configure an output:
1. Select Field setup from the main menu
2. Select Panel I/O configuration
3. Select Outputs and the select the corresponding output
4. Select the desired output operation mode and, if required, assign an output
group number
5. Press F4 (Enter) and then press F2 (Exit)
6. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit)
To enable or disable an output:
1. Select Field setup from the main menu
2. Select Panel I/O configuration
3. Select Outputs and the select the corresponding output
4. In the Control option, select ENB (enable) or DIS (disable)
5. Press F4 (Enter) and then press F2 (Exit)
6. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit)