54
User’s Manual
PMX_MULTI
Basic Functions
Locking the Panel Controls (Key Lock)
The key lock function can be used to prevent the settings from being
changed by mistake.
When the keys are locked, “LOCK” is shown in the display area.
There are three key lock types. Use CONFIG parameter CF03 to set the type.
• Key lock 1 (Loc1): Lock all keys except the OUTPUT and memory A, B, and C keys.
• Key lock 2 (Loc2): Locks all keys except the OUTPUT key.
• Key lock 3 (Loc3): Lock all keys and the rotary knob.
1
Configure all the parameters, such as the output voltage and output current, as
necessary.
2
Hold down LOCK until “LOCK” appears in the display area.
Key lock is enabled.
To release the key lock, hold down LOCK until “LOCK” disappears.
Tracking Function
The tracking function varies the outputs simultaneously.
The outputs of other channels change simultaneously along with the reference channel.
The outputs can be varied according to the amount of change (TRACKING 1: absolute value change) or
varied at the same percentage (TRACKING 2: percentage change).
If within the operating area, the outputs can change from 0 V (or 0 A) to the rated output voltage (or rated
output current).
You can specify the channels that will operate in tracking mode with CONFIG parameter CF09.
When set to tracking mode, parallel operation nor series operation can be used.
SELECT
OUTPUT
CH1
OUTPUT
ALL
CV
V
s
OFF
CC
A
s
ON
PRL
SER
TRACKING 12
LOCK
REMOTE
L AN
L AN
DEL AY
DEL AY SET
SET OVP
࣭
OCP
PRESET A B C
ALARM
%
%
