Kikusui PLZ-3WH Series, Operation Manual

Page: 67 / 172

Chapter 4: Operating Procedure
4-27
9: Interface Selects each interface operating environment.
1: GPIB Address GPIB address (the default is address 1).
2: Power-on SRQ Power-on service request
[Enable]
[Disable] (default)
3: MCB Address MCB address (the default is 15).
4: RS-232C Speed Baud rate
[9600 bps] (default)
[4800 bps]
[2400 bps]
[1200 bps]
5: RS-232C Data bit Data length
[8 bit] (default)
[7 bit]
6: RS-232C Stop bit Stop bit length
[1 bit]
[1.5 bit]
[2 bit] (default)
7: RS-232C Parity Parity bit
[None] (default)
[Odd]
[Even]
10: Resolution (I) Sets the current variation (resolution) per one jog click. (The default is 0.0100 A, but this
value is set to 0.0010 A for the PLZ153WH.)
11: Resolution (I/R) Sets the resistance variation (resolution) per one jog click. (The default is 0.0100
siemens, but this value is set to 0.0010 siemens for the PLZ153WH.)
12: Resolution (V) Sets the voltage variation (resolution) per one jog click. (The default is 0.010 V.)
13: Resolution (P) Sets the power variation (resolution) per one jog click. (The default is 0.100 W.)
14: Parallel Ope Sets the number of load units to be operated in parallel. (The default is 1.)
16: Calibration Calibration