Kikusui PLZ-3WH Series, Operation Manual

Page: 111 / 172

5-11
Chapter 5: Remote Control
Table 5.3-3
When another command is executed after the TRG buffer contents are defined by the TRIG:xxxx command and before
the TRG command is executed, the TRG buffer is cleared. While TRG buffer is being cleared, the TRG command
received is not executed. After the TRG command is executed, the TRG buffer is cleared. If the GET command is used
instead of the TRG command, the same sequence occurs.
If the TRIGRSET command is executed in CC mode, an error will result. (Diff. Mode 15)
If the TRIGISET command is executed in CR mode, an error will result. (Diff. Mode 15)
Header Data Action Backup
TRIGISET 0 to maximum rating [A] Sets the ISET value using the last TRG command. None
TRIGRSET Minimum to maximum Sets the RSET value using the last TRG command. None
resistance [OHM]
TRIGVSET 0 to maximum rating [V] Sets the VSET value using the last TRG command. None
TRIGPSET 0 to maximum rating [W] Sets the PSET value using the last TRG command. None
TRG Executes the last TRG:xxxx command and None
TRIGSTOP clears the TRG buffer. None