Kikusui PLZ-3WH Series, Operation Manual

Page: 41 / 172

4
4
Chapter 4 Operating Procedur
This chapter describes basic functions and operating procedures of the load unit.
4.1 Status of Display After Power-on ........................................... 4-2
4.2 Basic Operations on Front Panel ........................................... 4-3
4.3 Constant Current, Constant Resistance,
Constant Voltage, and Constant Power Modes ..................... 4-4
4.4 Basic Operating Procedure .................................................... 4-8
4.4.1
Operation in CC Mode ............................................ 4-8
4.4.2 Operation in CR Mode ............................................ 4-12
4.4.3 Operation in CV Mode ............................................ 4-15
4.4.4 Operation in CP Mode ............................................ 4-17
4.4.5 Saving and Calling Set Values ............................... 4-18
4.4.6 Switching Function ................................................. 4-21
4.4.7 Keylock Function .................................................... 4-23
4.4.8 Setup Function and Backup Memory ..................... 4-24
4.4.9 Configuration .......................................................... 4-26
4.4.10 Alarm ...................................................................... 4-28
4.4.11 Short Function ........................................................ 4-29
4.5 Sequence Operation .............................................................. 4-31
4.5.1
Description of Sequence ........................................ 4-31
4.5.2 Outline of Sequence Operation Setup .................... 4-37
4.5.3 Sequence Operation Setup Procedure ................... 4-38
4.6 External Control ..................................................................... 4-47
4.6.1
External Control of CC (Constant Current) Mode ... 4-49
4.6.2 External Control of
CR (Constant Resistance) Mode ............................ 4-51
4.6.3 External Control of CP (Constant Power) Mode ..... 4-53
4.6.4 External Control of Load on/off ............................... 4-54
4.6.5 External Control of Range Select ........................... 4-55
4.6.6 Trigger Signal ......................................................... 4-56
4.7 Parallel Operation .................................................................. 4-57