181922 Rev B
12
Controlled by ECCN:EAR99
PROPRIETARY INFORMATION –
Refer to the restrictions provided on the Title Page of this document.
EAR DATA
- Subject to the export control restrictions on the Title
Page of this document or file
SYSTEM RESET
FIRE:
After a fire, the system is restored to operational status as follows:
1.
Disconnect system power by removing the system fuses. The system has two fuses.
2.
Remove the Fire Extinguisher:
a. Disconnect the electrical connector on the extinguisher valve from the vehicle harness.
b. Install a shorting plug to the electrical connector on the extinguisher valve.
c. Remove the distribution piping from the valve outlet port and install the anti-recoil
plug.
WARNING! THE ANTI-RECOIL PLUG SHALL BE INSTALLED ON THE VALVE OUTLET
PORT AT ALL TIMES EXCEPT WHEN THE EXTINGUISHER IS CONNECTED
TO THE DISTRIBUTION PIPING OR WHILE THE EXTINGUISHER IS BEING
FILLED.
d. Loosen the mounting clamps and remove the extinguisher.
CAUTION! DO NOT ATTEMPT TO REBUILD THE EXTINGUISHER. HAVE THE FIRE
EXTINGUISHER REBUILT BY A QUALIFIED FIRE PROTECTION EQUIPMENT
COMPANY FAMILIAR WITH KIDDE DUAL SPECTRUM EQUIPMENT. REBUILD
SHALL INCLUDE SQUIB, VALVE SEALS, AND DRY CHEMICAL
REPLACEMENT.
3.
Blow out the distribution tubing with dry compressed air to insure the tubing is dry and free
of debris and/or residual agent.
4.
Replace any damaged or missing nozzle blow-off caps.
CAUTION! NOT INSTALLING ALL OF THE NOZZLE BLOW-OFF CAPS BEFORE
PREFORMING A DRY CHEMICAL CLEANUP CAN RESULT IN
COMTAMINATES GETTING IN THE DISTRIBUTION SYSTEM WHICH
COULD RESULT IN COMPROMISED PREFORMAMCE OF THE
SUPRESSION SYSTEM.
5.
Clean up dry chemical agent according to “Dry Chemical Clean-Up Procedure”, R9866.
6.
Repair and/or replace any damaged detection devices and/or electrical harnessing.
7.
Replace the fire extinguisher:
a) Inspect the new extinguisher; verify it is the correct part number to ensure it is the
correct configuration for the application and verify the anti-recoil plug and the shorting
plug are installed.
b) Install the extinguisher in the mounting bracket and oriented per the instructions on the
extinguisher nameplate. Tighten the mounting clamps. Do NOT connect the electrical
connector at this time.
CAUTION! THE EXTINGUISHER WILL NOT FUNCTION AS INTENDED IF ORIENTED
INCORRECTLY
