Keysight U8903B, User Manual

Page: 369 / 605

Test Sequence Application 7
Keysight U8903B User’s Guide 369
Table 7-46 SMPTE Level Sweep > Signal Generation settings menu description
Menu Description
Waveform
Press the Waveform softkey to select the waveform type.
– SMPTE 1:1
– SMPTE 4:1
– SMPTE 10:1
Output Press the Output softkey to select the output channel.
Sweep Config
Press the Sweep Config softkey to set the sweep configuration.
– Start
Set the start value for the sweep parameter.
– Stop
Set the stop value for the sweep parameter.
– Spacing
Select Log, Linear, or Custom for the sweep spacing.
– Points
Set the number of sweep points.
– Step Size
Set the step size for linear spacing. This setting is only available when spacing is set to Linear.
– Dwell Time
Set the delay between the sweep points.
– Edit Points
Edit the individual points value, insert or remove points, load points, and save the points.
Waveform Config
Press the Waveform Config softkey to set the waveform configuration.
– Track 1st Ch
If Track 1st Ch is enabled, the generator channel 1 waveform configuration settings will be copied to the other channels
and the waveform configuration settings for the other channels cannot be edited. Any changes made to channel 1
waveform configuration settings will be reproduced in the other channels waveform configuration settings. Disable the
Track 1st Ch to set the individual channels.
– Upper Freq
Set the upper frequency value.
– Lower Freq
Set the lower frequency value.
– DC Offset
Set the DC offset value.