2
Performance Tests
48
Keysight N1913/1914A Service Guide
Introduction
The performance tests described in this chapter test the power meter’s electrical
performance against the specifications detailed in
. They are used for
incoming inspection, during calibration cycle (also called periodic maintenance),
or after repairs have been made.
The following performance tests are described in this chapter:
–
“1 mW Power Reference Level Test”
–
“Output Standing Wave Ratio (SWR) Test”
–
–
“Absolute Accuracy Test (Average Path)”
–
NOTE
– This document does not provide a complete breakdown for these tests; it only
gives a brief overview of each, in line with Keysight’s recommendation that
the Keysight N7800 Series calibration software should be used at all times.
– Performance testing is limited to the measurement and verification of
warranted specifications.
– Some tests cannot be performed manually, and so the N7800 Series
calibration software is essential.
– Measurement uncertainty will not be addressed in this document (this is
handled by the N7800 Series software).
Summary of Contents for N1913
Page 1: ...Keysight N1913 1914A EPM Series Power Meters Service Guide...
Page 16: ...16 Keysight N1913 1914A Service Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK...
Page 18: ...18 Keysight N1913 1914A Service Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK...
Page 20: ...20 Keysight N1913 1914A Service Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK...