Keysight M9502A, User Manual, Page: 73 / 142

Keysight M9502A/M9505A AXIe Chassis User Guide 63
SFP Screens Using the Soft Front Panel
Below the Configure Trigger Routing table are three buttons:
– Reset to Factory Default:
This button resets the chassis trigger subsystem to
the factory default configuration, including setting TriggerInThreshold to
1.65 VDC, connecting Static 0 to all crosspoint switch inputs, and
disabling the Trigger Bus and Star Trigger Output Buffers.
– Save as Default State: This button saves the trigger subsystem configuration
as the new power-on default configuration, replacing the current power-on
default configuration. The just-saved configuration is re-applied using the
Restore from Default State button. Only one state can be saved.
– Restore from Default State:
This button restores the trigger subsystem to the
power-on default configuration. The power-on default configuration can
be a previous configuration saved by using the Save as Default State
button. Otherwise, the power-on default configuration is the factory
default configuration.
In the Simulation Mode, the Save as Default State button does not actually save
the configuration. The Restore from Default State always restores the Factory
Default configuration. The state is saved in the chassis hardware, hence, in
Simulation Mode, there is no ability to save or recall states.