Keysight U3045AM04 User’s and Service Guide
21
U3045AM04
Controlling the U3045AM04
Controlling the U3045AM04
This section will describe how to operate the test set with the analyzer.
A analyzer must be used to control the test set using the Test Set I/O interface
on the rear panel. There are three methods to control the test set. Multiport
mode is recommended due to ease of use and multiport calibration capability
(N-Port).
—
—
“Interface Control Mode” on page 31
.
—
“GPIB Control Mode” on page 35
Typeface Key Conventions
The following key conventions are used throughout this document.
— [HARDKEYS] are labeled front panel keys
— SOFTKEYS are indicated on the instrument display
Sweep Setup for Multiport and Standalone Modes
Due to the extra electrical length of the test set and test port cables, it is
recommended that the analyzer’s Sweep Setup be configured to Stepped
Sweep before calibrating. This is slower than the Analog Sweep, but is more
accurate. Stepped Sweep is available on all models.
1.
On the analyzer select STIMUL
U
S > Sweep > Sweep Setup.
2.
Select Stepped Sweep.
3.
Set the Dwell Time to 5
μs
> OK.
Figure 16
Sweep Setup
