Step 2: Install the PXI Modules
Before installing the PXI Modules
Install the Controller
Use the appropriate instructions below for installing the embedded controller
(Keysight models M9036A or M9037A) or remote controller (Keysight M9021A Cable
Interface with M9045B adapter for laptop PC or M9048A adapter for desktop PC).
Do not power up the controller until instructed to do so later in this
document.
Embedded Controller
If your solution contains a
Keysight M9036A or
M9037A Embedded
Controller, follow the
procedure below.
(For additional detail, refer to
instructions in the
or the
.)
1. Remove the
M9036A or M9037A
module from its ESD protective bag. Observe
(see page
).
2. Install the embedded controller in Slot 1 (see
icon above the slot) in the
chassis.
a. While holding
the module by
the inject-
or/ejector
handle and
making sure
the inject-
or/ejector
handle is
pushed down in
the unlatched
(downward)
position, slide
the controller
20
Keysight Y1299A-004 RF PA/FEM Reference Solution Startup Guide
