KEY RK-2006LSPz, Operation Manual

Page: 15 / 36

15
Igniter
Hysteresis loss of flame (temperature sensor). 1°C 250°C
Flame failure detection delay. 1s 500s
Fuel ignition time. 1min 15min
Ignition try count. 1 10
Furnace extinction time. 1min 30min
Furnace cleaning mode (See description).
Cleaning mechanism work time. 1s 900s
Cleaning mechanism retraction time. 1s 900s
Cleaning mechanism pause time. 1s 900s
Number shut downs before cleaning. 1 99
Minimum operating time without cleaning. 0h max-1h
Maximum working time without cleaning. min+1h 99h
CH pump
Central heating pump work mode (See description).
Central heating pump periodic work. NO YES
Central heating pump periodic work time. 1min 99min
HTW pump
Domestic water path (See description).
Domestic water heating hysteresis. 1°C 20°C
Boiler increase temperature during hot tap water heating. 2°C 20°C
Domestic pump work extension. NO YES
Domestic pump work extension time. 1min 10min
Mixing pump engaging temperature. 30°C 60°C
Mixing pump work hysteresis. 1°C 9°C
Thermostat
Boiler minimum temperature. 30°C 69°C
Boiler maximum temperature. 70°C 90°C
Boiler upper hysteresis. 1°C 20°C
Boiler power switching hysteresis. 1°C 9°C
Boiler protection hysteresis. 1°C 5°C
Boiler overheating temperature. 90°C 99°C
Burner power modulation. NO YES
Modulation factor. 1 20
No
Resume service settings.
Outputs test.
Service mode end.
5.1. Language selection.
RK-2006LSP controller interface offer the function of language selection. Number
of available languages depend on software version being used.
L A N G U A G E
E N G L I S H
5.2. Fan operation parameters.
Fan modulation during boiler start - selection of „YES” setting means that fan
speed modulation will be provided during boiler start.
F A N M O D . D U R I N G
B O I L E R S T A R T Y E S
Min. fan speed during heating up - this parameter is available, if the function of fan
modulation during boiler start is selected. This parameter specifies power of the fan
during boiler start.