Page 13
The commands are not case sensitive. The command lines are shown with spaces for clarity. No
spaces are required when entering commands.
All standalone units have ‘00’ as their default address. When multiple units are used as in an
expansion configuration, each unit will have a unique address. In this case, all below commands
should start with the Prefix:
‘A zz’
, where
zz = [01-99]
and represents the units System Address.
This will ensure the commands are sent to the correct unit.
Values for Commands:
Address
zz = 00-99
(Default standalone 4x4 is 00)
Inputs
xx = 01-99
(or A = All)
Outputs
xx = 01-99
(or A = All)
Output Volume
yy = 00-96
(Default is 80)
Output Bass
yy = 00-24
(Default is 12)
Output Middle
yy = 00-24
(Default is 12)
Output Treble
yy = 00-24
(Default is 12)
Output Balance
yy = 00-40
(Default is 20)
Output Delay
yy = 00-99
(Default is 00, each increment = 5.5ms)
Output Mute Interval
yy = 00-09
(Default is 00)
H
Help
PHI
Help with Input Setup Commands
PHO
Help with Output Setup Commands
PHC
Help with Control Setup Commands
PHT
Help with Status Commands
PN
Power On
PF
Power Off
System Output Set-Up Commands
To set Audio Configuration Type:
»
‘SP O xx T y’
To set the Audio Output Format Type:
»
Where xx = ‘01-99’ and is the Output number and y = ‘1-5’ and is the Configuration Type
desired.
»
Example:
To set Audio Type to 2 for Output 2, issue the command;
‘SPO02T2’
»
Example:
To set Audio Type to 1 for Output 3, issue the command;
‘SPO03T1’
»
Example:
To set Audio Type to 4 for All Outputs, issue the command;
‘SPOAT4’
»
See list of audio configuration types below:
»
Type 1
= Left & Right Analog Inputs to Left & Right Analog Outputs switching with Audio
Control plus PCM Inputs to PCM Outputs pass through (switching only and any Audio
type can be passed through PCM in this mode )
»
Type 2
= Left & Right Analog Inputs to Left & Right Analog Outputs switching with Audio
Control plus Composite Video Inputs to Composite Video Outputs (switching only)
