Kett LE-200C, Operating Manual

Page: 33 / 40

CONT (Continuance)
Measured values are usually held, but the hold mode can be released
to perform calibration and measurement when making measurements
on complexly shaped objects for which measurement values tend to
be unstable, thus allowing you to obtain stable values.
【 Operation Example 】 :
27
F. R. (Final Result: Overall statistical calculations results)
The Final Result function mode is used to obtain the overall statistical
calculations results for the measurement data from measurement
number N = 0001 to the final measurement made.
The operation is performed in the same way as the block result
function except that the F.R.5 key is used instead of the B.R.4 key.
When the final result is obtained the unit will request the lot number
for subsequent measurement.
The unit will move to the next measurement after the new lot number
is input. The next measurement will begin at N=0001, B=01.
Therefore all previous data is erased from memory when the final
result is obtained. Please note, however, the upper and lower limit
setting will remain. To change these setting perform the limit setting
procedure again.
Key Operations Display
* FUNCTION KEY
*
The calibration procedure after releasing the hold mode is the same
as in (3)-
2
above. However, in procedures
7
,
9
,
#
and
&
, the
ENT key is pressed when the display stabilizes with the probe held
against the measurement surface. The value is input when the buzzer
sounds. If you wish to print out the measured value, turn the printer on
and press the ENT key while the probe is held down against the
measurement surface. To return to the hold mode again, repeat the
same key operation procedure.
Note:
Hold mode set display :
* NF (FE)
Hold mode released display :
*