23
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
■
Selecting Offset Direction
Select whether the transmit frequency will be higher
(+) or lower (–) than the receive frequency.
1
Select the desired band.
2
Press
[F]
,
[SHIFT]
.
• Each time you repeat this key operation, the offset
direction changes as shown below.
Note:
◆
If the offset transmit frequency falls outside the allowable transmit
frequency range, transmitting is inhibited. Use one of the
following methods to bring the transmit frequency into the
allowable range:
•
Move the receive frequency further inside the band.
•
Change the offset direction.
◆
While using an odd-split memory channel or transmitting, you
cannot change the offset direction.
TM-G707E Only:
If you select “- -” for the offset direction, you cannot
change the default offset frequency (7.6 MHz).
■
Selecting Offset Frequency
Select how much the transmit frequency will be offset
from the receive frequency. The default offset
frequency on the VHF band is 600 kHz no matter
which market version; the default on the UHF band is
5 MHz (TM-G707A) or 1.6 MHz (TM-G707E).
1
Select the desired band.
2
Press
[MNU]
to enter Menu mode.
3
Select Menu No. 8 (OFS).
4
Press
[OK]
, then select the appropriate offset
frequency.
• The selectable range is from 00.00 MHz to
29.95 MHz in steps of 50 kHz.
5
Press
[OK]
again to complete the setting and exit
Menu mode.
Note:
After changing the offset frequency, the new offset frequency
will also be used by Automatic Repeater Offset.
TM-G707A/E
(VHF)
TM-G707A
(UHF)
TM-G707E
(UHF)
Simplex
+
−
Simplex
+
− −
−
1
2
Summary of Contents for TM-G707
Page 84: ......
