43
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
■
Using Program Scan
1
Select a frequency equal to or between the
programmed scan limits.
2
Press
[VFO] (1 s)
.
• The 1 MHz decimal blinks while scanning is in
progress.
• Scan starts at the frequency currently displayed.
• To reverse the scan direction, turn the
Tuning
control clockwise (upward scan) or counterclockwise
(downward scan), or press Mic
[UP]
/
[DWN]
.
3
To quit Program Scan, press any key other than
[MHz]
and Mic
[UP]
/
[DWN]
.
Note:
◆
The squelch must be closed for Scan to function.
◆
If the frequency step of the current VFO frequency differs from
that of the programmed frequencies, you cannot use Program
Scan.
◆
If the frequency steps of the lower limit and upper limit differ, you
cannot use Program Scan.
◆
If the current VFO frequency is within more than one
programmed scan range, the range stored in the smallest
channel numbers is used.
CALL/VFO SCAN
Use Call/VFO Scan to monitor both the Call channel and
the current VFO frequency on the selected band.
1
Press
[VFO]
to select VFO mode.
2
Select the desired band.
3
Select the desired frequency.
4
Press
[CALL] (1 s)
to start Call/VFO Scan.
• The 1 MHz decimal blinks while scanning is in progress.
5
To quit Call/VFO Scan, press any key other than Mic
[UP]
/
[DWN]
.
CALL/MEMORY SCAN
Use Call/Memory Scan to monitor both the Call channel
and the desired memory channel.
1
Recall the desired memory channel.
2
Press
[CALL] (1 s)
to start Call/Memory Scan.
• The 1 MHz decimal blinks while scanning is in progress.
• The Call channel on the same band as of the selected
memory channel is used for Scan.
3
To quit Call/Memory Scan, press any key other than
Mic
[UP]
/
[DWN]
.
Note:
The memory channel last used is scanned even if it has been
locked out.
Summary of Contents for TM-G707
Page 84: ......
