TK-2317
17
5. Attaching the Battery Release Lever to
the Case Assembly
1. Insert one side of the shaft into the hole at the lever fi tting
section on the case assembly
a
.
Caution: The thin spring (G01-4543-04) should be posi-
tioned above the two tabs of the lever.
2. Tilt the battery release lever slightly forward
b
, so that
the thick spring (G01-4542-04) is positioned below the
case surface.
3. With the thick spring positioned below the case surface,
attach the other side of the shaft to the case assembly
by pressing the battery release lever
c
until it snaps into
place
d
.
Caution: Be careful not to tilt the battery release lever
too forward.
If the battery release lever is pushed in this state where
the two tabs come below the case surface, there is a
possibility of damaging the two tabs.
DISASSEMBLY FOR REPAIR /
维修拆卸
A thin spring /
Shaft /
Tow tabs /
A thick spring /
a
b
c
d
5. 安装电池分离拨杆到机壳
1. 把轴的一侧插入到机壳的拨杆安装部的孔里。
a
注∶细弹簧 ( G01-4543-04) 必须安装到拨杆的 2 个突起上
面。
2. 轻轻地前推电池分离拨杆倾斜倒
b
，这样粗弹簧 ( G01-
4542-04) 就被定位在机壳下面。
3. 粗弹簧被定位到机壳下面之后，通过按电池分离拨杆
c
直到它嵌入位置
d
，轴的另一侧接触机壳组件。
注∶注意不要把电池分离拨杆倾斜得太靠前。
如果电池分离拨杆被推到分离拨杆下面的 2 个卡头的位置，
就有可能损坏这 2 个卡头。
细弹簧
轴
2 个突起的上侧
细弹簧
