TK-2317
16
3. Removing the TX-RX unit from the
Chassis
1. Remove the eleven screws
f
fi xing the TX-RX unit.
2. Remove the solder of the antenna terminal with a solder-
ing iron
g
.
3. Remove the solder of the positive terminal with a solder-
ing iron
h
.
Note: You can remove the TX-RX unit from the chassis
without removing the solder at the positive terminal.
However, in this case, you can not attach the packing
(G53-1605-03) that is on the positive terminal to the
chassis in assembling. So, it is advisable to remove the
solder on the positive terminal fi rst.
4. Remove the FPC from the fl at cable connector
i
.
5. Lift and remove the TX-RX unit from the chassis
j
.
4. Removing the Battery Release Lever
from the Case Assembly
1. Press the upper part of the lever toward the inside of the
case assembly. One side of the shaft will be removed
a
.
2. Lift and remove the battery release lever from the case
assembly
b
.
Note: Scratch and widen the glue hole if there is diffi culty
in removing the other end of the shaft.
No glue is required when you reassemble the battery re-
lease lever.
DISASSEMBLY FOR REPAIR /
维修拆卸
B
x2
B
x2
B
x2
>
8
2
B
B
B
B
B
@
:
3. 从机架拆卸收发单元
1. 卸下固定收发单元的 11 个螺丝
f
。
2.
用电烙铁烫开天线端子的焊锡。
g
3. 用电烙铁烫开电池正极端子的焊锡。
h
注∶不用烫下焊锡拆卸正极的端子，你也可以拆卸收发单
元。
但是组装时，正极端子连接的垫片 (G53-1605-03) 不能安
装到机架。因此，请先烫开正极端子的焊锡。
4. 从扁平电缆连接器拆卸 FPC。
i
5. 从机架抬起收发单元。
j
4. 从机壳拆卸电池分离拨杆
1. 向机壳的内侧按压拨杆上部之后，就可以卸下轴的一侧。
a
2. 拿起电池分离杆，就可以从机壳上拆卸下来。
b
注∶如果很难拆卸轴的其它端部时，请刮掉和扩展粘合孔。
当你重新组装电池分离杆时，则不需要粘合。
