Kenwood NX-1200 D K2, Function Reference

Page: 95 / 132

4 NXDN function
95
Using Scan (Scan)
Type
‘ ■
Standard model
■
Basic model
Description
Scan is the function to check whether the transceiver receives a call from other transceivers.
The transceiver sequentially searches for availability of signal on each channel, and the transceiver receives on
the channel where the signal is detected.
Two methods are available for Scan as shown below.

Single Scan
The transceiver scans target channels in the same zone.

Multi Scan
The transceiver scans all target channels in the target zones.
Operating the transceiver - -
Note
-
Configuration using FPU -
Using Scan ( Scan Type )
Type
‘ ■
Standard model
■
Basic model
Description
If a scan starts in the zone where “Single” is configured in
Scan Type , Single Scan is executed.
Or
, if the transceiver migrates during the scan to the zone where “Single” is configured in
Scan Type , Single
Scan is executed.
If a scan starts in the zone where “Multi-Zone” is configured in
Scan Type , Multi Scan is executed.
Or
, if the transceiver migrates during the scan to the zone where “Multi-Zone” is configured in
Scan Type , Multi
Scan is executed.
Operating the transceiver
- -
Note -
Configuration using FPU Scan Type : Edit > Scan Information > Scan
Scanning in One Zone ( Single Scan )
Type
‘
■
Standard model
■
Basic model
Description The transceiver scans using Single Scan all the added channels in the zone where the transceiver starts
scanning.
If a scan starts in the zone where “Single” is configured in
Scan Type , Single Scan is executed.
Or, if the transceiver migrates during the scan to the zone where “Single” is configured in
Scan Type , Single
Scan is executed.
Operating the transceiver Display during Scan Temporary Stop
Display during Scan Off
Transceiver behavior :

The icon blinks while paused.

The Scan LED is turned off.

Press PF_BTN[Scan].
Transceiver behavior :

Tone B sounds and scan is ended.

Scan icon is turned off.

Selected channel is displayed.

The Scan LED is turned off.
Note -
Configuration using FPU
Scan Type , Selected Channel Scan , Revert Channel Display , Scan LED :
Edit > Scan Information > Scan
PF_BTN[Scan]
PF_BTN[Menu]
Edit > Button Assignment > Side, Front
Scan Add
:
Edit > Zone Information > Channel Edit > General