Kenwood NX-1200 D K2, Function Reference

Page: 15 / 132

3 DMR function
15
Copying the Configuration Data to Another Transceiver ( Clone Mode )
Type
‘ ■
Standard model
■
Basic model
Description
Clone Mode can be used to copy the data configured for the transceiver to another transceiver.
Operating the transceiver

Turn the transceiver ON while pressing and holding the
[ Side 2] button.
Transceiver behavior :

The transceiver enters Clone Mode.

Press the PTT switch.
Transceiver behavior :

Tone A sounds from the transceiver and copying the data
starts.

The LED lights red.
Transceiver behavior :

Copy the data.

Copying the data ends.

The LED is turned off.
Note

The following data cannot be copied in Clone Mode:
・
Tuning Data
・
Embedded Message with Password
・
KENWOOD ESN Data
・
Model Name
・
Backup Data

If the data is copied to a transceiver having a different firmware version number, this may result in an error or a
failure of the transceiver to function correctly. In such a case, the cloned transceiver operation must be verified
prior to using this transceiver on a regular basis.

Refer to the service manual for instructions on how to operate the transceiver in Clone Mode, and for details
on the Clone function.
Configuration using FPU Clone
：
Edit > Optional Features > Optional Features 1 > Common 2 > Mode
Changing the Configuration of the Transceiver (Front Panel Programming Mode)
Type
‘
■
Standard model
□
Basic model
Description This mode can be used to change data, such as the frequency on a Conventional Channel, and to add a
Conventional Channel in the transceiver only.
Even if no KPG-D6/ D6N and PC is available, required data can be configured by using only the transceiver.
Operating the transceiver
Press [<B]
Transceiver behavior :

Press and hold [PTT]+[Side 1] during power on the
transceiver will enter into Front Panel Programming mode
with display of “PANEL PG”.

Press [S] to next stage.
Transceiver behavior :

Zone-Channel Selection stage.

“ZONE XXX” will be displayed to indicate zone number going
to be configured in next stage where XXX is the zone number.
Note

Pressing the PTT Switch and [Side 1] button places the transceiver in Front Panel Programming Mode.

Refer to the service manual for instructions on how to operate the transceiver in Front Panel Programming
Mode.
Configuration using FPU
Front Panel Programming : Edit > Optional Features > Optional Features 1 > Common 2 > Mode