SWEEPING SYSTEM
SERVICE MANUAL
ENGLISH
Edge 28B
1463165000(1)2007-02
7
SIDE BROOM HEIGHT CHECK AND ADJUSTMENT
NOTE
Brooms of various hardness are available. This procedure is applicable to all types of brooms.
Check that the side broom is at the correct distance from the ground, according to the following procedure:
Drive the machine on a level ground and lower the side broom.
Keep the machine stationary and turn on the side broom for a few seconds.
Turn off the side broom by pressing the switch (1), then lift it and move the machine.
Check if the size and orientation of the print left by the side broom are as shown in the figure (A, Fig. 1): the side broom
must touch the ground along a circle arc ranging from “10 o’clock” position to “3 o’clock” position.
If the print is not within specifications, it is necessary to adjust the broom height, according to the procedure shown in
step 2.
Turn the knob (13) clockwise or counter-clockwise to adjust the broom height up or down.
Perform step 1 again to check that the side broom is at the correct distance from the ground.
When the broom is too worn and can no longer be adjusted, replace it according to the procedure shown in the relevant
paragraph.
10
3
�
S301585
1.
•
•
•
•
•
2.
3.
4.
