Kensington CH-07D, Instruction Manual

Page: 3 / 16

3
0800 422 274
NZ
Read this manual thoroughly before first use , even if you are familiar with this
type of product. The safety precautions enclosed herein reduce the risk of fire,
electric shock and injury when correctly adhered to. Make sure you understand
all instructions and warnings.
Keep the manual in a safe place for future
reference
, along with any warranty information, your purchase receipt and the
original carton. If you sell or transfer ownership of this product, pass on these
instructions to the new owner.
Always follow basic safety precautions and accident prevention measures
when using an electrical appliance, including the following:
Electrical Safety and Cord Handling
• Voltage: Before plugging in the heater, make sure your outlet voltage and
frequency correspond to the voltage stated on the appliance rating label.
•
Electrical circuit: To prevent overloading a circuit, do not plug the heater into
a circuit that already has other appliances working.
• No adaptor, no extension cord: Do not use the heater with a power board or
double adaptor as this may overheat and create a fire risk. Do not use it with an
extension cord because the cord may overheat and cause a risk of fire.
•
WARNING: To reduce the risk of fire, electric shock or injury:
• Never touch the heater with wet or damp hands or feet.
• Do not use the heater if any part of it has become wet. Immediately call a
qualified service technician to inspect the heater and replace any part of the
electrical system that has been wet.
• Never spill liquid into the heater; never immerse the cord, plug or any part of
the appliance in water or any other liquid. Do not reach for an appliance that
has fallen into water. Switch off and unplug immediately.
•
Damage: Do not operate the heater with a damaged cord or plug, or after the
heater malfunctions or has been dropped or damaged. If the supply cord is
damaged, it must be replaced by the manufacturer or an authorised service
agent in order to avoid a hazard. Contact our after sales support line to arrange
an examination and/or repair.
•
Plug: It is normal for the plug to feel warm to the touch; however, a loose fit
between the AC outlet and plug may cause overheating and distortion of the
plug. Contact a qualified electrician to replace a loose or worn outlet.
• Protect the power cord:
• Do not twist or kink the cord or let it touch heated surfaces.
• Do not put any stress on the cord where it connects to the product.
• Arrange the cord away from any traffic area so no one will trip over it.
• Do not run the cord under carpeting; do not cover it with rugs, runners etc.
• Only operate the heater with the power cord fully unwound. Using it with the
cord coiled up could cause overheating and present a hazard.
General Safety Instructions