![background image](http://html1.mh-extra.com/html/kensington/ch-07d/ch-07d_instruction-manual_664244008.webp)
8
0800 422 274
NZ
Getting Started (Cont.)
Wall-Mounting
IMPORTANT!
• Only mount this heater on a
structurally sound, heat-resistant wall area that
is strong enough to hold the weight of the heater. If in doubt, consult a builder.
• The instructions below are for wall-mounting the heater onto a
masonry wall.
Please obtain expert advice if you want to wall-mount it to another type of wall.
• Make sure to install the heater at least 10cm above the floor.
• Do not connect the appliance to the mains power supply until completely
assembled, installed and adjusted.
L = 830mm
H = 400mm
L1 = 250mm
H1 = 254mm
To wall-mount the heater, follow the instructions below, or consult an expert. If the
castor wheels are attached, take them off the heater (see page 9).
• Decide where you want to position the heater on
the wall and mark the positions for the wall plugs,
following the illustrations.
• Drill 2 holes in the wall -- their diameter should be
wide enough so they just tightly contain the supplied
wall plugs.
• Insert the wall plugs and screws into the holes,
leaving the head to protrude approximately 2–3mm.
• Carefully position the heater over the large size of the
holes in the brackets, then slide it slightly down and
drop it gently onto the screws.
Summary of Contents for CH-07D
Page 1: ...MODEL NUMBER CH 07D N13275...