19
Courroie
Éclairage
Indicateur de
hauteur de poils
Protecteur de
surchage
Bouton de remise
en circuit
Nettoyeur de bords
(Non illustré)
Pédale de
hauteur de poils
Pédale de
relâchement
de manche
Numéros de
modèle/série
Power-Mate (Au bas)
®
Pedale de
relâche de
la rallonge
(Non illustré)
Détecteur de
poussière
Collet
Tube
télescopique
Bouton d'ajustement
de longueur du tube
Relâche rapide
PIÈCES ET CARACTÉRISTIQUES
Il est important de connaître les pièces et les caractéristiques de l’aspirateur pour l’utiliser correctement et en
toute sécurité. Lire cette section avant de l’utiliser
Power-Mate®
Objet Pièce Nº.
Pièce Nº.
aux Etats-Unis
au Canadá
Ampoule
20-5240
20-40600
Courroie
20-5218
20-40118
4
5. Rotate
cover back.
Press cover
firmly until side
and rear tabs
snap into place.
Make sure there is no gap between the
cover and base.
6. Turn Power-Mate
®
upside down and
replace two (2) cover screws.
Rear
Latches
Side
Latch
2. Place agitator
assembly back into
Power-Mate
®
.
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
belt path.
NOTE: See
PARTS AND
FEATURES
for belt num-
ber.
3. Line up
front of
cover and
base. Rest
cover on
front edge
of base as
shown.
Motor
Drive
Belt
Path
End Cap
Agitator
Cover
Base
4. NOTE: On dirt sensor models be sure
that the board is upright and the wires are
tucked back in place.
1. Remove Power-Mate
®
cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
LIGHT BULB CHANGING
Push In
And Turn
3. Push in and turn
bulb clockwise, to
replace. Bulb must
not be higher than
15 Watts(130 Volts).
4. Reinstall Power-Mate
®
cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
NOTE: See PARTS AND FEATURES for
bulb number.
Push In
And Turn
ENGLISH
