Mechanical installation
Kendrion INTORQ | BA 14.0224 | 02/2021
21
5
Mechanical installation
This chapter provides step-by-step instructions for the installation.
Important notices and information
NOTICE
The toothed hub and screws must not be lubricated with grease or oil.
5.1
Design of end shield and shaft
¾
Comply with the specified minimum requirements regarding the end shield and the shaft to ensure a
correct function of the brake.
¾
The diameter of the shaft shoulder must not be greater than the tooth root diameter of the hub.
¾
The brake flange must be supported by the end shield across the full surface.
¾
Depending on the type of installation, additional clearing bore holes may be required.
¾
Keep the end shield free from grease or oil.
Minimum requirements of the end shield
Size
Run-out
Concentricity
Tensile strength R
m
(of the end shield's material)
[mm]
[mm]
[N/mm
2
]
01
0.02
0.05
> 250
02
0.02
0.05
03
0.02
0.10
04
0.02
0.10
05
0.02
0.10
Tab. 5:
Design of the motor end shield
