16
5. Install the wire behind the cutting head unit se pictures below. Crank the down the winch
so that the wire get all the way pulled out, crank up the winch again so that the wires rolls
up neatly on rod.
6. Adjust the unit so that it is straight. Crank up the unit until theres tension on the wire. Use
a spirit level to check if the unit is straight and which side needs to be djusted if necessary.
Tighten all bolts and fastenings.
Crank up the winch down and up again un-
til the wire is rolled neatly on the rod. Use
a spirit level to check the level of the unit.
If the unit is not straight. Adjust the position
by adjusting the bolts.na
ASSEMBLY - CUTTING HEAD UNIT AND WINCH
Summary of Contents for 21-SV500E
Page 26: ...26 Table of contents DRAWING I CUTTER HEAD FRAME...
Page 27: ...27 Table of contents DRAWING II HEIGHT ADJUSTER DRAWING III FEET OF CUTTER UNIT...
Page 28: ...28 Table of contents RAWING IV CUTTING HEAD UNIT...
Page 29: ...29 Table of contents RAWING V SAWBAND...
