Vehicle PTZ Camera
User Manual
30
30
2)
If the intelligent function has linked to a preset, it displays “Already Set” behind “
Enable Presets
”. On
this interface, user can edit or delete the set linkage;
3)
Behind “
Programme
”, there are 32 numbers for selection. Select the saved set number and select a
number from the dropdown list of “
Associated preset bits
” to link to the preset;
4)
Select a direction from the dropdown list of
Guard Line Direction,
“A
”, “B
” or “A
&&B
”. Take
“A
” as an example, when selecting this direction, only when objects move from A to B the system
will detect it and trigger an alarm;
5)
Target Filter
: to set target area. Click
“
Edit
” and drag the mouse in the scene to draw a rectangle.
Click
“
Stop
” after finishing and drag the slide bar of “
Max and Min Target Ratio
” (1% by default).
Moving objects exceeding max and less than min will not trigger an alarm when they enter the guard
line(s);
6)
Area Setting
: to set guard lines. Click
“
Edit
” and drag the mouse in the scene to draw a guard line.
User can click its starting point or end point to adjust its length and angle, and drag the slide bar of
“
Sensitivity
” to set the guard line’s sensitivity to moving objects;
7)
Duration
: user can set multiple durations and set different start time and end time for each duration.
Please refer to Step 4) in Motion Detection part;
8) Check
“Linkage Type”
and
“Save”
to make settings take effect.
4.3.4 *Enter Guard Area
Enable this function in the interface to detect specific area at real time. Once any moving object enters the
guard area, an alarm will be triggered.
Go to
Settings > Event > Intelligent Function > Enter Guard Area
and configure.
Setting steps:
1) Check
“
Enable
”;
2)
If the intelligent function has linked to a preset, it displays “Already Set” behind “
Enable Presets
”. On
this interface, user can edit or delete the set linkage;
3)
Behind “
Programme
”, there are 32 numbers for selection. Select the saved set number and select a
number from the dropdown list of “
Associated preset bits
” to link to the preset;
4) Target Filter: to set target area. Click
“
Edit
” and drag the mouse in the scene to draw a rectangle. Click
“
Stop
” after finishing and drag the slide bar of “Max and Min Target Ratio” (1% by default). Moving
objects exceeding max and less than min will not trigger an alarm when they enter the guard area(s);
5) Area Setting: to set guard area. Click
“Edit” and click mouse to draw a closed area made up of 3 to 6
points in the scene. Right click or click the starting point or end point to close the area;
6) Drag the slide bar of
“
Sensitivity
” to set the sensitivity of the guard area to moving objects. The higher
the value is, the more sensitive it is to the moving objects;
7)
Time Threshold
: The system will trigger an alarm after the target entering the guard area for a certain
period of time, for example 5s. Time threshold can be configured and the default is 5s;
8)
Duration
: user can set multiple durations and set different start time and end time for each duration.
Please refer to Step 4) in Motion Detection part;
9) Check
“Linkage Type”
and
“Save”
to make settings take effect.
