A100
Operation and handling
Operating instructions V1.03
26
© KEBA
5.6
Execution of the manual measurement
For executing a manual measurement, use of the measuring aid is recom-
mended. This allows the measurement result to be reached in less time and
with greater accuracy. In many cases, measurement accuracy is also greater
because the measuring aid makes it possible to align the device parallel to
the bending edge.
Minimum leg length
For manual measurement using the measuring aid, the following minimum
leg lengths apply, depending on the angle to be measured:
Angle
Minimum leg length
30°
50 mm
60°
35 mm
90°
25 mm
120°
20 mm
150°
10 mm
Installation of the measuring aid
To install the measuring aid on the device, proceed as follows:
Fig. 5-9: Installing the measuring aid
1) Position the two upper guiding lugs of the measuring aid on the upper
recesses of the device (
1
).
2) Fold the lower part of the device in the direction of the measuring aid so
that the two lower bending lugs of the measuring aid rest within the
lower recesses of the device (
2
).
Information
If installed correctly, the measuring aid rests on the device completely.
