KEB COMBIVERT F5 Series, Instructions For Use Manual

Page: 28 / 72

Device size 24 26 27 28 29
Housing size U U U P P
Cooling mode (L=air; W=water) L L W L W L W
Number of modules for master/slave – – – – – –
Input data
Mains phases 3
Permitted mains forms TN system
Rated input voltage U
N
/ V 400
Input voltage range
U
in
/ V 340…480 ± 0%
Mains frequency f
N
/ Hz 50 / 60 ± 2
Rated input power
S
N
/ kVA 125 173 208 256 319
Rated input current
I
N
/ A 180 250 300
1)
370 460
Max. permissible mains fuse type gR / aR 250 350 400 500 630
Output data
Rated output voltage U
outN_dc
/ V 680
Output voltage range
2)
U
_dc
/ V 530…840
Overvoltage switch-off (E.OP) U
OP_dc
/ V 840
Power supply/regenerative rated current
3)
I
outN_dc
/ A 180 250 300
4)
370 460
Max. regenerative DC current 30 s
I
out_max_dc
/ A 270 313 375 462 575
Rated switching frequency f
SN
/ kHz 8 4 8 8 4
5)
4
5)
Max. switching frequency
f
S_max
/ kHz 8 8 8 8 4 4
Other data (referring to the rated data)
Overcurrent cut-off (E.OC)
I
OC
/ % 180 150 150 150 150
Overload current (E.OL) 30 s
I
OL
/ % 150 125 125 125 125
Max. permissible DC link capacity C
ext
/ mF 45 43 40 35 35
Max. AIC charging current (=>
6.5
)
I
AIC
/ A 226 226 226 98 98
Max. external charging current (=> 6.5 ) I
ext
/ A – – – –
Max. permissible total charging current (=>
6.5
)
I
pre
/ A 226 226 226 98 98
Mains input circuit (=> 6.5 ) Type D1 D1
Permissible DC fuses =>
„DC fuses“
Short-circuit factor at the connection point (
S
kn
/
S
N
) 15 <
S
kn
“ / < 350
10 <
S
kn
“ /
< 350
Power dissipation at rated operation
P
BR
/ W 2230 2550 3500 4500 3000 3800
Max. heat sink temperature
t
_max
/ °C 90 90 60 90 60 90
6) 7)
90
6)
1)
The input current of the drive converter must be limited to the rated current of the AIC / LCL filter, if
necessary.
2)
The operation is dependent on the voltage setpoint and the U
OP
limit (=> Programming manual ).
3)
Measured at a reference voltage of 680 V DC.
4)
Limited by the rated current of the DC-terminal ! The input current must be limited to 300 A for input
voltages < 400 V.
5)
Must be set to 4 kHz for AIC operation (factory setting 2 kHz) !
6)
Special settings are required for this device sizes (Reduction of the max. heat sink temperature to
85°C, => Programming manual ).
7)
Max. ambient temperature T
a
of 35°C.
28
UNIT DATA