KEB COMBIVERT F4-S/1.2, Applications Manual, Page: 23 / 96

ru - Parameter
23
ANTRIEBSTECHNIK
Shows the binary coded status of the terminal input signals after the strobe, triggering
and logical interconnection through the di-Parameter
Bit -No. Decimal Value Input Terminals
0 1 ST (Control Release) 14
1 2 RST (Reset) 14
2 4 F (Forward) 13
3 8 R (Reverse) 12
4 16 I1 (Programmed. Input 1) 4
5 32 I2 (Programmed. Input 2) 5
If an input is triggered, then the corresponding decimal value is diplayed. If several
inputs are triggered, then the sum of the decimal values is displayed.
ru.17 displays the results of the output function table (do. 1 to do. 2). If the output
condition is met, then the corresponding decimal value is displayed. If several output
conditions are met, then the sum of the decimal values are displayed.
Bit - No. Decimal value Output Condition
0 1 Out1 Condition (do. 1)
1 2 Out2 Condition (do. 2)
Displays the parameter set currently active.
This means: - the number of the parameter set in which the inverter operates is
shown
- the number of the parameter set in which the parameter values
are changed by bus is not shown
Checks the analog channel Ref.
Shows the current value of the Ref, while 100% = 10V.
The continuous load of the inverter is analyzed by this parameter in order to prevent
OL (punctual load reduction) from occurring. Error OL is triggered when the OL-
counter reaches 100 % . The count is shown with a 1 % resolution.
ru.29 shows the actual heat sink temperature in °C. Resolution = 1 °C.
Internal Input
State (ru.16)
Internal Output
State (ru.17)
Actual Parameter
Set (ru.18)
Ref2 Display
(ru.23)
OL - Counter
Cisplay (ru.24)
Heat Sink Temp-
erature (ru.29)