31
Q:
Helicopter dithering under position mode, especially when flying near ground.
A:
Check following items
√
Decrease Flymentor 3D sensitivity
see section 4.2.1
If AUX channel is used
modify
sense
in
transmitter
;
If not, modify it in software.
√
The mounting place of CCD may be too low
,
please
try
to mount it higher.
√
Try to increase the travel of aileron and elevator.
√
Maybe
there
are
something
enter
eye
shot
of
CCD
.
√
Maybe
some plants swing under helicopter and they are in eye shot of CCD. If then, you
should switch to balancing mode.
Q:
Flight is not stable, especially when flying in upper air
A:
Clean lens of CCD frequently, and the lens should keep away from vent-pipe.
Q:
How to fly above low contrast environment? such as snow ground, water surface ...
A:
Positioning
mode
can
not
be
used
in
these
environments
,
you
must
switch
to
balancing
mode.
Q:
How to modify Flymentor 3D
sensitivity?
A:
If AUX channel is used
,
modify sensitivity in transmitter
;
If not, modify it in software through
PC. It is recommended to keep AUX empty because Flymentor 3D sensitivity
be
adjusted
frequently.
Q:
There is
thick smoke in eye shot of lens, what can I do?
A:
Don't let engine rich oil, and keep lens away from vent.
Q:
Flight is not stable under balancing mode and position mode both
A:
Maybe
vibration
cause
Flymentor 3D
working
abnormally
(
especially
when
use
oil
engine
),
you
can
try
to
add
sponge
between
Flymentor 3D
and
helicopter
.
Q:
The swashplate has some
actions
when
opening
/
closing
Flymentor 3D
A:
Because Flymentor 3D
needs
a
few
seconds
to
make
sync
with
helicopter
when
the
,
.
,
KDS Flymentor 3D
User
Manual
07-17-平衡仪说明书(英文).pdf 34
2009-8-3 15:06:49