18
Servo neutral should be set after reverse is set. You should adjust neutral to make the rocker at
suitable position. Normally, the position means angle between rocker and pole is 90
° ,
like
diagram
3.4.3
.
Diagram
3.4.3
Servo
neutral
Before adjusting
neutral, you should make the neutral of mechanism on approximate position,
then use software for
precise adjusting
.
90
°
90
°
3.4.2
Servo
neutral
You should aware that the neutral is mixed neutral, for example, when we adjust the aileron
neutral of CCPM120
°,
servo
1
and
servo
2
will
wiggle
at
the
same
time
(
opposite
direction
).
So
you
should
adjust
neutrals
by
following
steps
,
suppose
your
swashplate
is
CCPM
12 0°:
1
)
Adjust aileron neutral, make servo1 and servo2 same height. Don't care if the height is
enough.
2
)
Adjust elevator neutral, make servo1,servo2 and servo3 same height (swashplate was
horizontal).
3
)
Adjust pitch neutral, make the swashplate
at
proper
height
.
Adjusting of tail servo and servo4 are independent, you should adjust servo4 after aileron,
elevator and pitch.
*
Attention
:
to
avoid
injury
,
please
unmount
main rotor
and
shut
off
power
!
KDS Flymentor 3D
User
Manual
07-17-平衡仪说明书(英文).pdf 21
2009-8-3 15:06:47