22
4.1.1 Gyro settings
1
)
Gyro
sensitivity
The
sensitivity
of
gyro
can
be
set
from
- 10 0
to
+ 10 0.
The
positive
value
means
the
gyro
working
under
'
head
lock
'
mode
,
negative
value
means
the
gyro
working
under
'
normal
mode
' .
It
is
recommended
to
use
'
head
lock
'
mode
.
Same
as
other
gyros
,
the
sensitivity
should be as large as possible until the tail swings
.
If Flymentor 3D
has
connected
the
sensitivity
channel of receiver, the setting in this page
will be disabled, the gyro of Flymentor 3D
will
use
the signal from receiver as sensitivity
value. If
you
do
not
want
to
modify
sensitivity
value
frequently, you can keep the
sensitivity
channel empty (the blue line), then the channel on receiver can be
used
for
other
using
.
2
)
Yaw rate
This parameter controls the changing speed of direction. Normally, the value should be set
to maximum, but if you do not like fast changing of direction, you may adjust it as you want.
3
)
Yaw expotent
This parameter controls the exponent of rudder. Little value will cause fine response in slim
motion of stick. You may adjust it as you want.
4
)
Pitch to tail mix
This mix can improve effect when pitch changing. You can choose a suitable value
to make
better response of gyro to pitch changing.
5
)
Servo travel limit
This parameter controls the signal for tail servo, to avoid mechanical conflict of tail pitch
structure .
KDS Flymentor 3D
User
Manual
07-17-平衡仪说明书(英文).pdf 25
2009-8-3 15:06:47