
1.Preparation of information, fault diagnosis
Wrong
Wrong assembly
Instruction
Instructions for machine parts
Direction
Indicates the direction of action position and the direction of action.
Position and orientation of the matching parts folded with each other.
Bolt, assembly direction position--means wear
Gasoline
Gasoline has low ignition point and explosiveness.
Please work in a well-ventilated place. Fireworks are
strictly prohibited in workplaces or places where
Battery
Brake pad
Do not use highpressure air or dry brush to clean
brake components, but use vacuum aspirator or a
lternative methods to reduce asbestos fabric spre
ading into the air.
General safety matters
carbon monoxide
If it is necessary to run the engine in some operation
matters, please work in a well-ventilated place, and do
Exhaust gas contains toxic carbon monoxide, which
can make people lose their intuition and cause shock
and death.
Gasoline is extremely flammable, and may explode
under certain conditions, so don't let children touch it.
Battery will produce flammable hydrogen, so do not
let sparks near the battery, especially when charging.
Battery liquid contains sulfuric acid, please pay
attention not to touch eyes, skin and clothes. If you
accidentally touch it, please wash it with whom. If
you touch your eyes, you must seek medical
attention immediately.
If you don't swallow battery liquid, please use plenty
of water or milk mud, then take salt or vegetable oil,
NOTE
NOTE
NOTE
Summary of Contents for A180
