37
Shop Online
CLASSIC 800 Product Manual
Setup & Operation
5. Adjustment & “Calibration”
The CLASSIC 800 is a digital flow, level, interface and temperature switch/transmitter and is built to require
minimal maintenance and no calibration beyond proper installation and setup.
•
The Kayden Electronics Modules are completely digital and have no moving parts or mechanical trim
pots that could be effected by vibration or high unit cycles.
•
True temperature compensation is programmed into the firmware and is continuously factored into the
operation algorithms of the microprocessor.
•
The heater is a separate element from the sensors and is itself directly controlled by the
microprocessor.
Therefore, once properly setup, the CLASSIC 800 will be as stable and repeatable as the process in which it is
installed. For instance should the application change from Flow to Level or the media change from Hydrocarbon
to Water-based or the Flow Rate increase or decrease significantly it may be necessary to check and/or change
the setup parameters (Range, Heater Power, Set Point).
6. Using the Kayden RCM Software to Satisfy Preventative Maintenance Requirements
One feature of the Kayden RCM Software* is the Configuration function which automatically stores all setup
information and displays it on the Configuration screen within the software whenever the CLASSIC 800 is
connected to a PC. This information may be named, stored and emailed as a file to preserve all operation setup
parameters.
Therefore, the user may construct “Maintenance Only Setup Parameters” with a slightly different heater setting
and set point and save these as a file. This Maintenance Setup File could then be loaded in place of the normal
operating setup which will cause the display and relay function to change accordingly. Once this change is
observed the normal setup can be reloaded and the preventative maintenance requirement satisfied.
* The Kayden RCM Software is available upon request, at no charge on CD, when a new CLASSIC 800 is
purchased. Additional copies may be obtained at no charge from telematic.com. In addition to the software
you will need the SCA Serial Communication Adapter, the USB to Serial converter and communication
cable. These can be ordered online at telematic.com.
