Quick Setup Guide
2
CLASSIC
™
800
Shop Online
To configure or adjust the CLASSIC, perform the steps in the
order indicated by –
•
Perform steps 1 & 2.
•
Push RUN and verify Thermal Signal in your Flow/Level
operating condition.
•
Push SET and perform steps 3 & 4.
*If Relay 2 is not being used it is useful to configure the
settings for Relay 2 exactly the same as Relay 1.
1
3
3
4
Relay 1
Relay 2
4-20 mA Fault
Confi guration
2
2
100%
Thermal Signal
0% Thermal
Signal
4
4
Startup
Bypass Timer
Set Point 2
Set Point 1
1
Heater Power
Node Address &
Software Revision
4-20 mA
Polarity
START
FINISH
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
Press
SET
to continue or
RUN
to exit
*
*
Thermal Dispersion
Quick Setup Guide
3
Shop Online
RUN MODE
- Run Mode LED is ‘Flashing’
RUN
Press and hold to view the
Software Revision
and
Node Address
SET
Press and release to enter
Set Mode
(see table below
Left Arrow
Press and hold to view the LED-0 and LED-100 Pointers
on Baseline graph
Right Arrow
Press and hold to view Thermal Signal data on
Baseline Graph
1
Press and hold to view
Set Point 1
on Scaled Bar
Graph View
2
Press and hold to view
Set Point 2
on Scaled Bar
Graph View
SET MODE
- Run Mode LED is ‘Off’
RUN
Press and release to exit
Set Mode
and return to
Run Mode
SET
Press and release to proceed to next step of
Set Mode
Left Arrow
Adjust selection as per
Set Mode
function
Right Arrow
Adjust selection as per
Set Mode
function
1
No function in
Set Mode
2
No function in
Set Mode
CAUTION
Installation, connection and maintenance must be carried out by expert
technicians who have read these operating instructions. These operating
instructions include all-important information required for the installation and
operation of this product. They supplement the full Product Manual, and the
relevant national regulations with respect to the equipment as well as with
the maintenance activities.
!
Mounting Base Plate
Wire Positions
LOOP -
VAC-H
LOOP +
VAC-N
R2NC
COM
R2NO
+VDC
R2CM
485-T
R1NC
485-A (-)
R1NO
485-B (+)
R1CM
485-C
Display Panel Indicators:
Relay 1
On steady when Relay 1 is energized
Relay 2
On steady when Relay 2 is energized
Fault
Indicates a self-test error or fault condition
Set Point 1
On steady when viewing Set Point 1
Set Point 2
On steady when viewing Set Point 2
Run Mode
Flashing when switch is operating
Bypass
Flashing when the Start-up Bypass Timer is active
Thermal Signal
Displays Thermal Signal
The Thermal Signal increases as:
Flow
The flow rate increases
Level
The sensor is submerged
Interface
The sensor is submerged by the second liquid of
greater thermal conductivity
CLASSIC 800 Display Panel
Mounting Base Plate /
Terminal Assembly
32
Shop Online
