KAUO HENG
COMPUTERIZED FLAT KNITTING MACHINE
7.10 Racking mechanism
The rear bed can be racked four
(
4
)
inch(left right each 2 inches), the
initial position”0”. See the left selvedge of needle bed, the corresponding
position that the first needle of rear is on the left hand side of the first needle of
front. As shown in Fig.7.10.1.In editing instruction you can choose the left
racking or the right racking by one pitch.
Left rear
Left front
In each racking position the rear bed and the front bed must be kept in correct
corresponding relation. You check it with pushing one front needle to tuck
position, the hook of front needle and the knock-bit of rear bed should be at
the same position.
Fig.7.10.1 Initial position of needle bed
If there has racking instruction in programming, you must enter the test mode
to rack the needle bed in the set position before you execute run, and make
sure the racking mechanism is matched your programming.
If the corresponding position of needle bed is not proper, loosen the stepped
screws and adjust the rear bed to correct position, then tighten the stepped
screws after adjustment. Refer to Fig.7.10.2.
KH-300
OPERATION MANUAL
17
Right front
Right rear
Stepped screws
Fig.7.10.2 Adjusting the position of needle bed