Kärcher RLM 4, Operating Instructions Manual

Page: 54 / 444

54 RLM 4 GB
NOTE
Further menu items: see chapter 5.2
"Making the basic settings", page 52 .
7.2 Activating/deactivating the button tones
1. or * Key clicks
2. Activating/deactivating the button tones:
■
or Activate :
Activate the button tones.
■
or
Deactivate
:
Deactivate the button tones.
7.3 Activating/deactivating Eco mode
In Eco mode, the appliance switches to energy-
saving mode. This reduces the energy consump-
tion and noise emissions.
NOTE
With high and thick grass and for thick
rolled turf, this is not recommended or
may not be possible.
1. or
* EcoMode
2. Activating/deactivating Eco mode:
■
Activate
:
Activate Eco mode.
■
Deactivate
:
Deactivate Eco mode.
7.4 Setting the rain sensor
NOTE
Mowing when the grass is dry reduces
soiling.
By activating the rain sensor and setting
a delay time, it is possible to prevent the
appliance mowing when the grass is
wet.
If the rain sensor is activated, the appliance
moves back into the charging station when the
rain begins. It remains there until the rain sensor
has dried. Then it waits for the time period that is
set as the delay before it continues mowing. The
sensitivity of the rain sensor is adjustable.
1. or
* Rain sensor
2. Activating/deactivating the rain sensor:
■
or
Activate
:
Activate the rain sensor.
■
or Deactivate :
Deactivate the rain sensor.
3. Setting the delay of the rain sensor:
■
or
* After rain delay
■
xx hours xx minutes
Select the required value for the delay
with or and accept with .
4. Setting the sensitivity of the rain sensor:
■
or * Rain sensitive
■
Select the required value for the sensitivi-
ty with or and accept with .
7.5 Setting the mowing program
7.5.1 Setting the mowing program – General
1. Call up the main menu with .
2. or * Programs
3. Select the menu item with or and ac-
cept with .
4. Carry out the settings.
Note: The menu items are described in the
following sections.
7.5.2 Setting entry points
Learning entry points
1. Place the appliance in the charging station.
2. Switch on the appliance with
ON
OFF
.
3. Call up the main menu with .
4. or
* Programs
5. or
* Entry Point
6. or
* Interactive teach
7. or
* Start interactive entry
point teaching :
■
or Start . The appliance
moves along the boundary cable.
■
or
Set
when the appliance
has reached the required entry point. The
entry point is stored.
8. or
Set entry point 1
if no
entry point has been specified during the
teaching-in movement. If no entry point has
been specified here, the entry points are au-
tomatically specified.
9. or
Entry point x: XXm
if the
last entry point has been reached.