![background image](http://html1.mh-extra.com/html/karcher/rbs-6000/rbs-6000_original-instructions-manual_655077014.webp)
-
3
1 Rotary knob for dosing pump*
2 Switch for dosing pump*
3 Handle
4 Safety switch (brush)
5 Mains plug
6 Shutoff valves for nozzle pipes
7 Main switch
8 Water connection
9 Emergency-stop button
10 Incline crank
몇
WARNING
Risk of injury and damage! Observe the
weight of the system when you transport it.
This system can be transported on the bed
of a lorry laying down:
Remove the spacer rollers.
Tilt the system onto the brush side with
two people.
Slide the system onto the lorry bed.
Secure the system from sliding.
1 Splash guard
2 Pin
3 Expanding rivet
4 Angle profile
The two angle profiles are attached to the
frame with expanding rivets for transport,
remember the installation position of
the angle profiles for the assembly
process.
Hit the pins of the expanding rivets to-
ward the inside with a punch.
Remove the angle profiles.
Roll out the included spray guard and
place it on the square pipe.
Note:
The spray guard strips are ondulated on
their short side. During installation, this on-
dulation must face away from the brush.
Reinstall the angle profile.
Insert the expanding rivet through the
angle profile, spray guard and the
square pipe and press in firmly.
Hit the pin of the expanding rivet with
the hammer.
Repeat this process for all bores in the
angle profiles.
Fasten the two included spacer rollers
on the frame of the system.
Select the height according to the vehi-
cles to be washed.
Tighten the counter nuts.
The following systems do not include a
dosing pump in the standard scope of deliv-
ery:
–
1.286-235.0
–
1.286-245.0
–
1.286-345.0
–
1.286-435.0
–
1.286-445.0
Fasten the dosing pump on the frame of
the system with the included fasteners.
Control elements
Transport
Initial Start-Up
Install spray guard
Install the spacer rollers
Install the dosing pump
14
EN