VII Function adjustment
Note:
Note:
3. The standby power supply of DC products and AC / DC products must be replaced
with a new dry battery after the power is exhausted (as shown in the figure below)
3）If there is dirt in the induction eye window, please clean it in time to avoid affecting the use
effect.
4）If you find that the use effect is not good during use, please operate according to "VII:
function adjustment"
5)If you find that the flushing water is insufficient during use, please clean the filter.
6) For DC type (dry battery) products, when the dry battery voltage is lower than about 4.5V,
the indicator light will be red when the sensor eye has induction, indicating that the dry battery
voltage is insufficient and the battery needs to be replaced.
7) If you find that the AC type urinal flushing sensor is not inductive or the power supply is in
poor contact, please turn off the power immediately and find relevant professionals for mainte-
nance to avoid electric shock or other accidents.
battery box
Battery box cover
No.5 dry battery rack
when replacing dry batteries, correctly install four 1.5V
alkaline No. 5 dry batteries into the battery rack according
to the "+" "-" mark on the battery rack, then put the battery
rack into the battery box and fasten the cover of the battery
box. Old and new batteries cannot be mixed.
Remove the panel and adjust the function according to the installation method of the panel.
1. Water volume adjustment
Adjust water consumption .Firstly remove the panel and
adjust the regulating valve with a "straight" screwdriver
(as shown in the figure). Turn left to increase the water
volume and right to decrease water volume. (some types
of panels need to remove the lower frame before using
the screwdriver to adjust the regulating valve, and the
adjustment method is the same)
KARAT URINAL SENSOR
