T600 Tag Tester
DOC#:
UM 360420-835
REVISION F
Page 36 of 55
© Kapsch TrafficCom Canada Inc. 2022
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence
and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for
manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: UM 360420-835 REV F, T600 OPERATOR AND MAINTENANCE MANUAL.DOCX 03/28/2022 3:02
Kapsch TrafficCom
5.
I
NSTALLATION
The installation steps are outlined below. Begin installation by making the necessary hardware connections. After
installing the T600 hardware, install the software on the customer-supplied computer connected to the T600. Once
you have installed the software, launch the software and perform the configuration procedures.
System requirements for customer-supplied computer
The customer-supplied computer must meet the following requirements in order to run the T600 software and
successfully communicate with the T600 tag tester.
Operating system:
Windows XP, Windows 7, Windows 8 /8.1
COM ports:
two available RS-232 serial ports (DB9).
USB ports:
one available USB port if using the hand-held bar code scanner.
Installing the T600 hardware
You need to connect the power cables to the TTU and the communication cables between the TTU and the customer-
supplied computer. If you have the optional hand-held bar code scanner, you need to connect it to the computer.
Prerequisites: -
Ensure a minimum of 10 ft. between TTUs.
- Ensure a minimum of 3 ft. between a TTU and a T500 Tag Programmer.
- Ensure a minimum of 1ft. between the TTU and OBUs not being tested.
T600 connections
Connect one end of the serial null-modem cable to the HOST port on the back of the TTU. Connect the other end
to a computer COM port.
Connect one end of the serial scanner cable to the SCANNER port on the back of the TTU. Connect the other end
to a computer COM port.
Connect the TTU power supply to the AC outlet. Connect the power supply cable to the power connector on the
back of the TTU.
Optional hand-held bar code scanner connections
Connect and configure the hand-
held bar code scanner as outlined in the manufacturer’s instructions (Symbol
LS2208 Product Reference Guide, 72E-58808-07).
