Ka
Control
for Door Air Curtains
INSTALLATION AND OPERATING INSTRUCTIONS
5
Door air curtains
1.96
2. Important Information / Safety Information
Installation, assembly and maintenance work on electrical units
should only be performed by a qualified electrician in compliance with
the VDE guidelines.
Wiring should comply with the applicable VDE regulations and
provisions laid down by the regional electricity providers.
Non-compliance with these regulations and operating instructions can
result in the units malfunctioning with consequential damage and
danger to persons and property. The units can be incorrectly wired by
the wires being swapped – danger of fatal injury! Disconnect all parts
of the system from the mains power supply and prevent them from
being reconnected before starting any connection and maintenance
work!
Please read these instructions in full to ensure correct and proper
installation and the correct operation of the KaController.
Please note the following safety-relevant information:
• Disconnect all parts of the system that are being worked on.
• Ensure that the system cannot be accidentally re-connected!
• Before commencing the installation/maintenance work, wait until
the fan has stopped when the unit is switched off.
• Caution! Pipes, casings and fittings can become very hot or very cold
depending on the operating mode!
• Qualified personnel must have undergone training to provide them
with adequate knowledge of the following:
•
Safety and accident prevention regulations
•
Guidelines and recognised technical regulations, i.e. Association
of German Electricians (VDE) regulations
•
DIN and EN standards.
•
Accident prevention regulations VBG, VBG4, VBG9a
•
DDIN VDE 0100, DIN VDE 0105
•
EN 60730 (Part 1)
•
Technical wiring regulations (TABs) issued by the regional
electricity providers
The products should be protected from any moisture during installation.
Check the application with the manufacturer in case of any doubt. Any
use other than the use specified above is deemed not to be correct and
proper. The operator of the unit is solely responsible for any damage
arising as a result of this. Correct and proper use is deemed to include
adhering to the installation instructions described in these instructions.
Modifications to the unit
Do not undertake any modifications or upgrades on the KaController or
door air curtain unit without discussing these with the manufacturer as
these can impair the safety and operation of the unit.
Do not undertake any work on the unit that is not described in this
manual. On-site systems and cabling must be suitable for connection to
the intended system!
