Ka
Control
for Door Air Curtains
INSTALLATION AND OPERATING INSTRUCTIONS
41
Door air curtains
1.96
11.4 Programming Key
Programming Key
After the parameters have been set, the setup can be simply copied
to other door air curtain PCBs with the help of the programming
key. Please follow the following steps to copy setup:
1. Disconnect the previously programmed door air curtain
KaControl circuit board.
Read parameters
2. Set the DIP switch of the programming key to Read mode
(DIP1=OFF, DIP2=OFF). The DIP switches are located underneath
the cover!
3. Plug the key into the 4-pin plug on the door air curtain circuit
board.
4. Press the button on the programming key.
If the copy is successful, the red LED will light up followed by the
green LED
Loading parameters
5. Remove the programming key and set the internal DIP switches of
the programming key to Write mode (DIP1=OFF, DIP2=ON).
6. Repeat steps 3 and 4 to write the parameters to the Venkon
circuit board.
Important note:
The new door air curtain circuit board should also be disconnected
before writing the parameters.
The programming key is not supplied as standard with the unit
and can be ordered from Kampmann Customer Service as a
non-standard accessory.
The software versions of the control circuit boards must be identical
when reading and writing the parameter sets (see parameter P000).
It is not possible to read parameters from a control board using
software version "P000=10" for instance and then write the
parameters to a control board using software version "P000=15".
Important note:
The new door air curtain circuit board
should also be disconnected before
writing the parameters.
