Kaindl SSG 600 A-DC, Operating Instructions Manual

Page: 11 / 28

K
AINDL
-S
CHLEIFTECHNIK
B
EDIENUNG
Basic adjustment of the saw blade
Place support arm (pic. 1/19) to 0 degree
Open fixing lever (pic. 2/58) for fixation unit (pic. 1/14)
Open fixation screw (pic. 2/57)
Open clamping lever screw (pic. 2/42)
Open saw blade support (pic. 1/23)
Advise: for saw blades with diameter smaller than 200 mm, use the smaller flange
(ø 50 mm)
Use the spacer ring, corresponding to the boring hole of your saw blade
Place the saw blade on the arm. (The inside of tooth must show to the left).
Advance finger (pic. 2/23) place to the middle of inside tooth, close fixation screw (pic. 2/57)
Adjust saw blade in order the advance finger support comes in contact with the stop dog (pic. 4/79)
or adjust diameter as shown in (pic. 3/65)
Close clamping screw (pic. 2/42)
Place clamping unit (pic. 1/14) parallel to the opposite holder below and fix with lever. Pay attention,
that the saw blade can still be turned by hand without force.
Fixation of saw blade (only SSG 600 automatic)
Adjust knurled screw, depending on thickness of saw blade. Pay attention, that the saw blade
can still be turned by hand without force.
Knurled screw
11