K
AINDL
-S
CHLEIFTECHNIK
B
EDIENUNG
Test run of the automatic
Potentiometer
Transport
to graduation 3
Potentiometer
Schleifen
to graduation 3
Switch No. 1 to
Belüften
Switch No. 2 to
Start
Machine is running
Check if the feed cylinder pushes the ball of the stop dog inside the sleeve completely (pic. 4/79)
By adjusting the throttle valve, you can control faster of slower
move-out
of the feed cylinder
By adjusting the throttle valve, you can control faster of slower
move-in
of the feed cylinder
The adjustment of the potentiometer (pic. 5 transport), effect a change of the time-period between move-
out and move-in of the feed cylinder
Adjustment of grinding feed by the throttle valve, effects a faster or slower move-out of the grinding
cylinder
Adjustment of grinding feed by the throttle valve, effects a faster or slower move-in of the grinding
cylinder
The adjustment of the potentiometer (pic. 5 transport), effect a change of the time-period between move-
out and move-in of the grinding cylinder
Place the shut down magnet on the saw blade in front of the sensor (pic. 1/13)
When the magnet is coming below the sensor, by turn of the saw blade, the machine must stop
automatically. Mark the position of the magnet on the saw blade
In case the automatic does not stop, the sensor (pic 1/13) must be placed lower, closer to the magnet
and fixed again.
Sharpening the inside tooth
Press porting arm (pic. 1/19) against the stop dog (pic. 3/70)
Adjust the grinding feed by use of the hand wheel (pic. 1/9)
Remove the magnet
After the first two teeth are sharpened correctly, place the magnet on it’s marked position
The machine now sharpens on each tooth the adjusted surface and stops automatically after one
complete turn.
Attention!! By removing the magnet, the automatic will keep on
running
Switch (pic. 5) to stop
Check surface of the sharpened inside tooth, if not, start for a second turn.
For the second turn, the adjustments will be taken automatically
Concluding of grinding operation
Motor off, both switches (pic. 5 Einrichten, Stop) to the left position
13
Summary of Contents for SSG 600 A-DC
