Optisure Remote User’s Manual
6
March 2018
INSTALLATION
2.5
Rear Panel Connections
!
These tasks should be undertaken only by competent
personnel.
DANGER
Electric
Shock Risk
All the connections to the rear panel are electrical
connections. Exercise due caution, particularly when
connecting to external alarm circuits which could be at high
potential.
Connections to the rear panel of the instrument are explained in the following sections.
2.5.1 Power Supply Input
The AC power supply is a push fit into the power input socket as shown in
Figure 3.
Figure 3
Power Supply Input
The method of connection is as follows:
1.
Insure that both ends of the power cable are potential free, i.e. not
connected to an AC power supply.
2.
Check that the
ON/OFF
switch on the power supply connector is switched
to
OFF
.
3.
Push the IEC connector firmly into the power input socket.
4.
Connect the free end of the power cable to a suitable AC power supply
source (voltage range 85 to 264 V AC, 47/63 Hz) and switch on the AC
supply. The instrument may then be switched on, as required, by the
power
ON/OFF
switch.
Summary of Contents for Optisure Remote
