Kaco blueplanet 3.0 TL3 M2 WM OD IIG0, Manual

Page: 49 / 93

4 1 2 3 4
EPC (extended power
control)
NOTE: EPC settings
Fallback Power
0 – 100 %
1. Set fallback power.
2. Set time until shutdown takes place.
4 1 2 3 4
PC (power control)
NOTE: The PowerControl function monitors compliance with
the specifications set above for cos-phi, Q and P.
Fallback time
0 – 65535 s
1. Set fallback time for external power specification.
2. Transfer values with Apply button.
NOTE: After the set fallback time, external (RS485 or Modbus)
specifications for cos-phi, Q and P are reset to the respective
set fallback value (cos-phi constant, Q-con-stant or fallback
power).
.
NOTE: If the fallback time is set to 0s, external settings for
cos-phi, Q and P are not reset (operation continues with the
last received setpoint).
4 1
2
3 4
Power rampup active
NOTE: Power ramp-up is used to ramp up the power gradu-
ally. More detailed information at:
[See section 10.4.2
}
Page 69]
4 1 2 3 4
Power rampup gradi-
ent
1 – 600 [% / min]
F Set increase.
4 1 2 3 4
Rampup on every con-
nect
Status
Rampup on first con-
nect
Status
Rampup after grid fail-
ure
Status
Password Protection
Status
1. Activate option.
2. Activate optional password protection.
3. Confirm action field
4 1 2 3 4
Priority mode
Q-Priority | P-Prior-
ity
F Set priority for reactive power – Q or active power – P.
NOTE: When it comes to P priority, the reactive power adjust-
ment range is limited subject to the active power that is cur-
rently available and fed in.
4 1 2 3 4
Activation threshold
with overfrequency
50.2 – 70 (Hz)
Activation threshold
with underfrequency
40 – 45 (Hz)
1. Set frequency thresholds for activating the power limitation with
overvoltage.
2. Set the frequency thresholds for activating the power limitation
with undervoltage.
4 1 2 3 4
Power reduction P(U)
NOTE: To prevent the device from shutting down due to over-
voltage protection, the active power can be regulated in addi-
tion to reactive power control in order to reduce the active
power feed-in whereby the output voltage is reduced.
4 1 2
3
4
P(U) operation mode
Off | On
F
Activate the control process.
Off : Deactivates dynamic grid support using dynamic reactive current.
Dynamic grid support remains active on account of immunity to inter-
ference.
Manual Configuration and operation | 9
KACO blueplanet 3.0 TL3 KACO blueplanet 4.0 TL3 KACO blueplanet 5.0 TL3 KACO blueplanet 6.5 TL3 KACO
blueplanet 7.5 TL3 KACO blueplanet 8.6 TL3 KACO blueplanet 9.0 TL3 KACO blueplanet 10.0 TL3
Page 49
EN